Hi,
I would like to connect my SATA hard drive to fitPC2i connector via onboard P30 pin holes.
Can you recommend the suitable socket?
An what is the pin assignment for the pin holes since I cannot find it in the manual.
Tq
fitPC2i SATA connection
Re: fitPC2i SATA connection
fitPC2i supplied with such a connector. Are you talking about fitPC2 SBC?
Gabriel Heifets
Fit-PC2/3/IntensePC support.
Fit-PC2/3/IntensePC support.
Re: fitPC2i SATA connection
Yes, the SBC type that is used in Darwin OP Humanoid.
Re: fitPC2i SATA connection
Please contact sales@fit-pc.com for details.
Gabriel Heifets
Fit-PC2/3/IntensePC support.
Fit-PC2/3/IntensePC support.
Re: fitPC2i SATA connection
Ok. I will contact sales but at the same time since I need the SATA interfacing working urgently, can I have the SATA pin assignment onboard fitPC2i SBC? I will make my own connector.
Re: fitPC2i SATA connection
Sure
P1-GND
p2-Sata TX+
p3-Sata TX-
p4-GND
P5-Sata RX-
P6-Sata RX+
p7-GND
P8-NC
P9,10- +5V
P11-NC
p12-NC
P1-GND
p2-Sata TX+
p3-Sata TX-
p4-GND
P5-Sata RX-
P6-Sata RX+
p7-GND
P8-NC
P9,10- +5V
P11-NC
p12-NC
Gabriel Heifets
Fit-PC2/3/IntensePC support.
Fit-PC2/3/IntensePC support.
Re: fitPC2i SATA connection
Thanks for the pin assignment.
I was informed by your sales department that the type of connector is ADP-SATA but they only sell in volume.
Do you know where can I purchase only for small quantity (5 units)
I was informed by your sales department that the type of connector is ADP-SATA but they only sell in volume.
Do you know where can I purchase only for small quantity (5 units)
Re: fitPC2i SATA connection
This is a custom PCB made by a Compulab. You can check availability at our resellers
Gabriel Heifets
Fit-PC2/3/IntensePC support.
Fit-PC2/3/IntensePC support.